الوصف

Passive holder with tilt swivel. 2 keys included. For device with UAG Metropolis Series Case. With AMPS, Vesa 75/100 holes.

معلومات فنية

This holder is to be used when you want to secure your Surface Pro 8 and still have it easy accessable.

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your device without having it easy removable. The holder is made of extra strong plastic and is equipped with a lock. In order to remove the device from the holder you need the key, two keys are included. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

التعليمات

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it goes into place in the holder. Push the lock downwards and press the button to lock.

3. To remove the device from the holder: Use the enclosed key to open the lock. Slide the lock upwards. Pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

التوافق

• Microsoft : Surface Pro 8