الوصف

With USB-cable. 2 USB ports: QC 3.0A + 2.4A. With tilt swivel. 12/24 Volt. Fits devices with skin that has the following dimensions: Height: 150-165 mm, Width: 88 mm, Thickness: 2-11 mm.

معلومات فنية

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. The charging box has two USB ports: QC 3.0A + 2.4A. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle.

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto a ProClip mounting platform.

Fits devices with skin that has the following dimensions: Height: 150-165 mm, Width: 88 mm, Thickness: 2-11 mm. (May fit for skins thicker than 11 mm, depending on shape/design of the edges).

التعليمات

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder.

3. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder.

4. The holder is in place.

التوافق

• Apple : iPhone 13 Pro
• Apple : iPhone 12 Pro
• Apple : iPhone 13
• Apple : iPhone 12
• Apple : iPhone XR
• Apple : iPhone 11