مرحبا بكم في موقعنا الجديد..!!

Active holder for fixed installation

رقم الصنف : 713158

3A charging. 12/24V. With Easy-switching system. With vibration dampeners. Fits SM10/15 Pistolgrip with Bumper (SM10-TRIG-800) and fits Pistolgrip Long Range without Bumper (SM15-TRIG-L00).

M3 Mobile SM10-series

M3 Mobile SM15-series

more...

الكمية

إنتهى من المخزن

الوصف

3A charging. 12/24V. With Easy-switching system. With vibration dampeners. Fits SM10/15 Pistolgrip with Bumper (SM10-TRIG-800) and fits Pistolgrip Long Range without Bumper (SM15-TRIG-L00).

معلومات فنية

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. 12/24 Volt. The product is E-approved. Connect the power cable with a 3 A fuse. 3 A charger. Professional installation recommended. The rubber vibration dampeners help to eliminate vibrations when mounted onto a vehicle operating in rough road conditions. You have full access to all buttons and outlets when the device is in the holder. The charging device connects to the unit automatically when you put the unit in the holder.

  • Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 3A fuse. Professional installation recommended. Attach onto a Pedestal Mount.

  • Easy-switching system:

  • The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

  • التعليمات

    Please read all of the instructions and look at the pictures before attaching the holder.

  • 1. Attach the mount: Place the mount into the desired position and attach it with the enclosed screws.
  • Image
  • 2. Put the device in place: Hold the device above the mount. Slide/press it straight into the mount so it is porperly held in place.
  • Image
  • 3. Remove the device: Pull the device straight out from the mount.
  • Image
  • 4. The holder is in place.
  • Image

    التوافق

    • M3 Mobile : SM10-series
    • M3 Mobile : SM15-series

    السلة