الوصف

Adjustable MultiStand. Fits devices with height 140-195 mm. Mounting adapter and screws included. Black.

معلومات فنية

Adjustable MultiStand. Fits devices with or without protective case/skin, with a total height of 140-195 mm. You can connect e.g. a charging cable to the device when it is in place in the MultiStand, all buttons and connectors are easy accessable. If you want a more secure grip, you can tighten the locking wheel on the back side.

Convenient to use anywhere at home, in the car or in the office. Diminished risk to drop it, since the stand is easier to grip than the device itself. You can use the stand in several angles, just adjust the position depending on area of use. Also adapted for use in the lap, or on a wall or any other flat surface with the enclosed mounting adapter (item no 215461).

Tablets should not be installed onto a car’s dashboard if they block the view or block key controls. The ProClip is designed for installation of smaller devices (phones), not for large devices (tablets). If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

التعليمات

Please read all of the instructions and look at the pictures before installing.

1. Place the mounting adapter into desired position and screw it into place with the enclosed screws.

2. Place the MultiStand over the mounting adapter and slide it downward into place.

3. To place the device in the MultiStand: Place the upper part of the device into the upper part of the MultiStand. Press the device upward/forward so the top part of the MultiStand slides upward. Press the lower part of the device forward into the MultiStand. For a more secure fit: Press the top part of the MultiStand downward and lock it into position by tightening the wingnut on the back side.

To remove the device from the MultiStand: Loosen the wingnut on the back side. Press the device straight upward so the top part of the MultiStand slides upward. Pull the lower part of the device toward you and slide the device downward and out of the MultiStand.

4. The MultiStand is in place.

التوافق

...