الوصف

Passive holder with tilt swivel. 2 keys included. For device with UAG Case.

معلومات فنية

This holder is to be used when you want to secure your Surface Pro 4 and still have it easy accessable.

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your device without having it easy removable. The holder is made of extra strong plastic and is equipped with a lock. In order to remove the device from the holder you need the key, two keys are included. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.

Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

التعليمات

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. Mounting onto a MultiMoveClip: To place the holder, slide the tilt swivel into the MultiMoveClip. To remove the holder, push the release tab on the MultiMoveClip and slide the holder upward and away from the MultiMoveClip.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it goes into place in the holder.Push the lock downwards and press the button to lock.

4. To remove the device from the holder: Use the enclosed key to open the lock. Slide the lock upwards. Pull the upper part of the device out from the holder and then lift the device up and out from the holder.

التوافق

• Microsoft : Surface Pro 6
• Microsoft : Surface Pro 4
• Microsoft : Surface Pro 7
• Microsoft : Surface PRO 2017