الوصف

For cable attachment, for use with Apple original Lightning to 30-pin Adapter Cable. With tilt swivel. 2 keys included.

معلومات فنية

This holder for cable attachment is to be used when you want to secure your iPad and still have it easy accessable. The holder is crashtested and approved for use on Brodit's headrest mount. The holder is also perfect for use in stores, at exhibitions and any place where you want to use your iPad without having it easy removable. Made of extra strong plastic and equipped with a lock. In order to remove the iPad from the holder you need the key, two keys are included.Mounted onto a tilt swivel so you can adjust the angle and switch between portrait and landscape mode.

The holder can, combined with an Apple cable, be used for charging your iPad. First you mount the cable into place onto the holder, then it connects automatically to your iPad every time you place the device in the holder.

Note! Cable not included.

The cable attachment holder can be combined with Apple original Lightning to 30-pin Adapter Cable (Apple article. no. MD824ZM/A).

Tablets should not be installed onto a car’s dashboard if they block the view or block key controls. The ProClip is designed for installation of smaller devices (phones), not for large devices (tablets). If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

التعليمات

Please read all of the instructions and look at the pictures before attaching the holder.

1. Place the connector of the cable in the hole on the side of the holder. Carefully press the connector downward and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into place in the holder. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw the holder onto the attaching plate. Tighten the screw so the holder is firmly in place, but still can be adjusted.

2. Slide the device sideways carefully into the holder. Press the lock sideways onto the left part of the holder. Press the button to lock.

3. Use the enclosed key to open the lock. Remove the lock by slidning it sideways away from the holder. Slide the device sideways carefully out of the holder.

4. The holder is in place. Switch between portrait and landscape mode by turning the holder into desired position.

التوافق

• Apple : iPad Mini (A1432, A1454, A1455)